DURKOPP ADLER 755 A

Programming
Service Instructions 755 A/756 A - 00.0 - 02/2019 271
5.1.15.7 Time after roll-off until lift-up  p. 346
5.1.15.8 Roll-off Time  p. 346
5.1.15.9 Roll-off Speed  p. 346
Zipper cutter On/Off  p. 295
5.2 Global parameters
5.2.1 Set positioning point seam begin./center/end  p. 358
5.2.2 Adjust transport clamp  p. 360
Lower transport clamp automatically On/Off  p. 360
5.2.2.2 Clamp down: Time to next action  p. 360
5.2.2.3 Speed to corner knife position  p. 360
5.2.2.4 Speed to waiting position  p. 360
5.2.2.6 Delay till clamp moves to seam begin.  p. 360
Automatic transport clamp return On/Off  p. 360
5.2.3 Set needle thread-clamp/-catcher/-tension  p. 361
5.2.3.1 Time: Thread clamp open  p. 361
5.2.3.2 Seam end: mm till thread clamp opens  p. 361
5.2.3.3 mm with needle thread catcher open  p. 361
5.2.4 Zipper cutter  p. 358
5.2.4.1 Set zipper cutting time  p. 358
5.2.6 Adjust corner knife  p. 358
5.2.6.1 Duration of corner knife On  p. 358
5.2.7 Maximum hook thread counter  p. 358
Needle thread monitor On/Off  p. 358
Transport clamp quick adjustment  p. 358
5.2.11 Set machine process speed  p. 359
5.2.18 Set password protection  p. 362
Set counting direction of piece counter UP/DOWN  p. 359
Knitwear mode On/Off  p. 359
6.0 DAC internal For DA staff only
7.0 DAC update  p. 400
Menu item
Option/described
on page