C 11 25
9.1 Lifting the vehicle with hydraulic lifts, lifting points
f
The hydraulic lift must be rated for at least 10t.
f
Always choose a horizontal surface with adequate load rating as installation surface
for the hydraulic lift!
f
Make sure that the hydraulic lift is securely and correctly positioned!
f
The hydraulic lift is only intended to lift a load and not as a support. Work should only
be performed to and under raised vehicles when they have been secured and cor-
rectly supported to prevent them from tilling over and rolling or sliding away.
f
Roller-type jacks must not be moved when under load.
f
Chocks or supporting beams positioned so that they cannot be shifted or tilted must
be adequately dimensioned and be able to take the corresponding weight.
f
There must not be anyone on the vehicle while it is being lifted.
f
All raising and lowering work must be carried out uniformly with all hydraulic lifts in
use! Always check and observe horizontal alignment of the load!
f
Always carry out raising and lowering work with several people together, with an ad-
ditional person monitoring progress!
f
Only positions (1) and (2) in the left and right side of the vehicle are permissible lifting
points!
To Next Page
Loading...
Need help?
General
