Dynapac SD2500C User Manual

D 30 27
Conveyor limit switches - PLC ver-
sion
The mechanical conveyor limit switches
(1) or the ultrasonic conveyor limit
switches (2) control the material flow on
the relevant half of the conveyor. The
conveyors should stop when the materi-
al has roughly reached the area below
the auger tube.
A
This requires that the auger height has
been adjusted correctly (see chapter E).
A
In vehicles with a PLC control system,
the deactivation point is set on the re-
mote control.
1
2

Dynapac SD2500C Specifications

General

Brand	Dynapac
Model	SD2500C
Category	Construction Equipment
Language	English