D 41 17
1.2 Preparation for transportation
- Close the hopper with switch (36)/(37).
- Engage both hopper transport safeguards.
- Lift the screed completely using switch (62), set the crossbeam lock.
- Turn the travel drive preselector (15) to zero.
- Activate set-up mode function (65).
- Fully extend the levelling cylinders with switch (56),(58)/(59).
A
To extend the levelling cylinders, levelling operating mode (126)/(130) must be
switched to "MANUAL" (LED OFF) on the remote controls.
- Use switch (42)/(43) to adjust the screed to the basic width of the paver finisher.
m
Lift the auger if necessary!
A
The drive is locked by an engine start with drive lever out of center position.
To start the drive, the lever must be put into center position before.
To Next Page
Loading...
