D 41 6
1.1 Starting the paver finisher
Before starting the paver finisher
Before starting the diesel engine and beginning operation, the following steps must
be performed:
- Daily maintenance of the paver finisher (see chapter F).
m
Check the operating hours counter to determine whether further maintenance work
should be conducted.
- Check the safety devices and protective devices.
"Normal" starting
- Set the drive lever (13) to the centre position and the travel drive preselector (15) to
minimum.
- Insert the ignition key (11) in position "0".
A
It is impossible to start the vehicle, if one of the emergency stop buttons (10) / (120)
is depressed.
(Error shown on the display)
- Press the starter button (12) to start the engine. Do not let the starter run perma-
nently for more than 30 seconds; allow for a break of 2 minutes after every attempt!
Caution! Possible subsequent damage!
- No additional consumers (light, heater, etc.) may be
switched on when starting.
- Do not switch the consumers on until the engine has
reached a speed of >1000 revs.
To Next Page
Loading...
