1.
[Call up the main menu] :
Ä
Chapter 7.7 ‘Main menu’ on page 73
2. [Operating mode] - [T
imer] .
3.
[Click Next] to save the setting.
ð
Screen change to the selection of the timer interval (Seven-day programme)
4. [Select Seven-day programme] .
ð
Screen change to the selection: ‘
Timer’ - [Seven-day programme]
5. Select T
imer (up to seven different Seven-day programmes are possible).
ð
Screen change to the setting for ‘Timer 1’: ‘Switching point’
6.
Press the button to close the Seven-day programme without saving.
ð
The screen switches back to the overview: [Operating mode] .
7. Use the scrollbar to set the time / hours.
8. Select time / minutes.
9. Use the scrollbar to set the time / minutes.
10.
Press the button Next.
ð
Screen change for the setting: ‘ON duration
’
11. Use the scrollbar to set the minutes.
12. Select seconds.
13. Use the scrollbar to set the seconds.
14.
Press the button Next.
ð
Screen change for the setting: ‘Capacity
’
15. ‘Set the Capacity in L
’ in the place before the decimal point using the scrollbar.
16. Select the field for entering the value after the decimal point.
ð
The colour changes to dark blue, which indicates that the field is ready for input.
17. ‘Set the Capacity in L
’ in the place after the decimal point using the scrollbar.
18.
Press the button Next.
ð
Screen change for the setting: ‘W
eekday’
19. ‘Select weekdays
’ .
ð
A check mark is set in the selection field.
20.
Press the button to save the settings and return to the selection: ‘Operating
mode’.
21.
By pressing the button, you can return to the [main menu].
22.
By pressing the button, you can return to the [operating display].
Control / Software
90417102276 Rev. 5-02.2020
To Next Page
General
