7.10.12.2 [Batch] - [Initial preparation]
Fig. 67: Batch - [Initial preparation]
1.
[Call up the Main menu] :
Ä
Chapter 7.7 ‘Main menu’ on page 73
2.
[Select Configuration] :
Ä
Chapter 7.10 ‘Overview - Configuration’ on page 92
3. Use the scrollbar to scroll to the [menu item Batch] .
4. [Select Batch] .
ð
Screen switches to the selection level [Batch]
5. ‘Select Initial preparation
’ .
ð
The option field ‘Initial preparation’ is marked.
6.
[ Click Next] to save the setting.
ð
Screen change for the setting: ‘Initial preparation
’ / ‘Quantity’.
7. Enter the quantity in litres (before the decimal point) using the scrollbar
.
8. ‘Select quantity after the decimal point
’ .
9. Enter the quantity in litres (after the decimal point) using the scrollbar
.
10.
Press the button Next.
ð
Screen change for the setting: ‘Initial preparation
’ / ‘Capacity’.
11. Enter the capacity in percent (%) using the scrollbar
.
12.
Press the button.
ð
The setting is saved, and the screen switches back to the batch overview
.
13.
Press the button to return to the menu: [Configuration].
14.
By pressing the button, you can return to the [main menu].
15.
By pressing the button, you can return to the [operating display].
Control / Software
116417102276 Rev. 5-02.2020
To Next Page
Loading...
Need help?
General
