7.14 Import and export functions
7.14.1
Import/export of the configuration
The configuration data can be updated via a USB stick to load the data to other pumps,
for example. This simplifies setting work when using multiple pumps of the same version
within a metering line as not every individual pump needs to be configured.
Export to USB data carrier:
W
e recommend using an empty or newly formatted USB stick to avoid
problems when saving data!
In order for the USB export and import function to be executed correctly, a
suitable USB flash drive must be used.
For this, a USB drive that is not too large (up to approx. 8gb), in the format
[FAT32] must be used.
If the desired function cannot be called, the USB drive has not been
detected properly and should be formatted as described above. If the
function is still not available after the formatting, it is recommended to
change the USB drive.
Fig. 77: Import/export of the configuration
Preparations for importing and exporting databases:
1. Use a blank (formatted) USB stick
NOTICE!
When using a USB memory stick, it must be formatted using F
AT 16
or FAT 32 as otherwise it will not be detected by the pump. The size of
the memory stick should not be too large as the data volume does not
require too much space and this could result in read errors.
2. On the USB stick, create the directory ‘ECOADD’ .
3. Create the (sub)directory ‘EXPOR
T’ in the directory ‘ECOADD’ .
4. Create the (sub)directory ‘IMPOR
T’ in the directory ‘ECOADD’ .
Control / Software
130417102276 Rev. 5-02.2020
To Next Page
Loading...
Need help?
General
