9 Operation
Personnel:
n
Operator
n
Specialist
Protective equipment:
n
Chemical-resistant protective gloves
n
Protective eyewear
n
Safety shoes
9.1 Switching the pump on/off
Fig. 83: ‘EcoAdd’
1 On/off button
All entries / settings are made via the “touch-sensitive screen”.
1.
The pump is switched on and of
f via the ‘ON/OFF button’
(Fig. 83, pos. 1).
2. After switching on, the pump is ready for operation.
ð
At start-up, the pump shows the info screen with the display of the determined
technical data for the connected components.
3.
By pressing the ‘start button’ the operation of the pump is started.
4.
Pressing the ‘pause button’ stops the pump from operating.
ð
The ‘operation
’ screen stops and the pump goes into standby.
5.
By pressing the ‘ON/OFF button
’
(Fig. 83, pos. 1) the pump can be switched off
again.
ð
The ‘operation
’ screen goes out and the pump is switched off.
9.2 Configuration of the pump
The pump must be configured before operation and this process is
described in:
Ä
Chapter 7.10 ‘Overview - Configuration’ on page 92.
Operation
139 417102276 Rev. 5-02.2020
To Next Page
Loading...
Need help?
General
