7.12 Operating data
Here all operating data since commissioning or since the last reset of the metering pump
can be retrieved. All operating data is stored for a maximum of 1 year
.
Fig. 75: Operating data
1.
[Call up the Main menu] :
Ä
Chapter 7.7 ‘Main menu’ on page 73
2.
[Select Configuration] :
Ä
Chapter 7.10 ‘Overview - Configuration’ on page 92
3. Using the scrollbar on the right side of the screen, scroll to the [Operating data] .
4. [Select Operating data] .
ð
The screen changes to [Operating data].
5. Select the required ‘Operating data
’ :
n Quantity
n Motor runtime
n V
essel change
n Alarms
n Service
n Press start
n Pulse mode
n Reset?
ð
Screen switches to the required ‘
Operating data’.
6. If the menu item ‘Operating data
’ ‘reset?’ has been selected, a red screen is
displayed. There are two function buttons in the header.
Press the
button to cancel the reset operation.
The data remains saved.
ð
The screen switches back to the overview of the ‘Operating data
’
7.
Press the button to delete all the operating data that has been saved up to that
point.
ð
The screen switches back to the overview of the ‘Operating data
’
8.
By pressing the button, you can return to the [main menu].
9.
By pressing the button, you can return to the [operating display].
Control / Software
128417102276 Rev. 5-02.2020
To Next Page
Loading...
Need help?
General
