7.10.7 Metering enable
With the metering enable function activated, the pump only runs if an external enable
contact is closed at terminal 20 and terminal 21 (see
Ä
Chapter 6.4 ‘Electrical installation’
on page 56 and
Ä
Chapter 7.9.2 ‘Operating mode [Manual] (with ‘metering enable’)’
on page 79). The selected operating mode does not affect the use of the metering enable
function. A missing enable function is indicated in the display with a symbol.
Fig. 53: Configuration: Metering enable
Factory setting: No metering enable
[Metering enable] - setting:
1.
[Call up the Main menu] :
Ä
Chapter 7.7 ‘Main menu’ on page 73
2.
[Select Configuration] :
Ä
Chapter 7.10 ‘Overview - Configuration’ on page 92
3. Use the scrollbar to scroll to the [menu item Metering enable] .
4. [Select Metering enable] .
ð
Screen switches to the [selection Metering enable].
5. If required, select the selection field ‘W
ith metering enable.’ .
ð
A check mark is set in the selection field.
6.
Press the button.
ð
The setting is saved, and the screen switches back to the configuration overview
.
7.
By pressing the button, you can return to the [main menu].
8.
By pressing the button, you can return to the [operating display].
Fig. 54: Metering enable on the operating screen
If the Metering enable function is activated, a white X with an orange
background appears in the top right-hand corner of the start screen to
indicate waiting for an enable pulse.
Control / Software
102417102276 Rev. 5-02.2020
To Next Page
Loading...
Need help?
General
