9.4.2 Container change with the preset [acknowledge man.[
Fig. 86: Empty signal: Changing a container
1.
Press the ‘empty signal display
’
on the operation screen.
To enter the setting, press the displayed empty signal ‘for approx.’ 3
seconds.
2.
If a password prompt is displayed, the access code must be entered (
Ä
Chapter
7.7.2 ‘Open the main menu with the access code activated’ on page 74).
ð
The screen switches to the information screen for the ‘Empty signal’.
3. Changing a container:
- Remove the suction pipe from the empty container
.
- Replace the empty container with a full one.
- Put the suction pipe back into the full container.
DANGER!
It is essential that the personal protective equipment (PPE) described
on the product data sheet (safety data sheet) for the metering medium
is used.
WARNING!
Risk of slipping due to fluid in the operation and provisioning
area!
–
Wear non-slip, chemically resistant shoes when working.
– Place product containers in a tank to prevent a slipping hazard
caused by leaking fluids.
ENVIRONMENT!
Immediately soak up any leaking liquids with a suitable binding agent
and dispose of properly
.
ð
The pump detects the new fill level via the connected suction pipe.
4. Following a detected container change, the pump automatically resumes operation
with the last settings.
Operation
144417102276 Rev. 5-02.2020
To Next Page
Loading...
Need help?
General
