7.10.6 Auto start
The feature [Auto start]
determines whether the pump is set to “Pause” when the mains
connection is re-established following a power cut or if the pump should immediately start
running again in the set operating mode.
CAUTION!
The operator of the pump is responsible for avoiding the risk of an
accidental startup of the pump after the power is reconnected using
suitable higher level measures!
Fig. 52: Configuration: Auto start
Factory setting: No Auto start
[Auto start] - setting:
1.
[Call up the Main menu] :
Ä
Chapter 7.7 ‘Main menu’ on page 73
2.
[Select Configuration] :
Ä
Chapter 7.10 ‘Overview - Configuration’ on page 92
3. Use the scrollbar to scroll to the [menu item Auto start] .
4. [Select Auto start] .
ð
Screen switches to the [selection Auto start].
5. If required, select the selection field: ‘W
ith Auto start.’ .
ð
A check mark is set in the selection field.
6.
Press the button.
ð
The setting is saved, and the screen switches back to the configuration overview
.
7.
By pressing the button, you can return to the [main menu].
8.
By pressing the button, you can return to the [operating display].
Control / Software
101 417102276 Rev. 5-02.2020
To Next Page
Loading...
Need help?
General
