7.10 Overview - Configuration
Fig. 44: Overview: Configuration
Selection of the configuration:
1.
[Call up the Main menu] :
Ä
Chapter 7.7 ‘Main menu’ on page 73
2. [Select Configuration] .
ð
The screen switches to the overview: [Configuration].
3. Select the configuration setting (system parameters).
4.
By pressing the button, you can return to the [main menu].
The following system parameters can be set:
n
Ä
Chapter 7.10.1 ‘Pump name’ on page 93
n
Ä
Chapter 7.10.2 ‘Date / time’ on page 94
n
Ä
Chapter 7.10.3 ‘Language’ on page 94
n
Ä
Chapter 7.10.4 ‘Access code’ on page 97
n
Ä
Chapter 7.10.5 ‘Unit ’ on page 100
n
Ä
Chapter 7.10.6 ‘Auto start’ on page 101
n
Ä
Chapter 7.10.7 ‘Metering enable’ on page 102
n
Ä
Chapter 7.10.8 ‘Empty signal’ on page 103
n
Ä
Chapter 7.10.9 ‘Alarm relay’ on page 106
n
Ä
Chapter 7.10.10 ‘Metering chemical’ on page 107
n
Ä
Chapter 7.10.11 ‘Service interval’ on page 112
n
Ä
Chapter 7.10.12 ‘Batch’ on page 114
n
Ä
Chapter 7.10.13 ‘Container size’ on page 118
n
Ä
Chapter 7.10.14 ‘Oval gear meter’ on page 119
n
Ä
Chapter 7.10.15 ‘Diaphragm breakage’ on page 124
Control / Software
92417102276 Rev. 5-02.2020
To Next Page
Loading...
