8.2 Language selection
The pump is set to display a language selection screen the first time it is
switched on to ensure that the operating language is suitable for the on-site
operating personnel.
The language selection screen is displayed in English because this makes
it easiest to select from the languages available and English is widely
understood.
Fig. 80: Language selection after starting the pump ‘EcoAdd’
Language selection after switching on the pump for the first time:
1.
‘Press the ON/OFF button’ on the pump.
ð
The pump switches on.
The ‘language selection page
’ is displayed.
2. Select the required system language:
The following languages can be selected:
n English
n Spanish
n German
n French
n Italian
n Czech
3.
Press the button Next.
ð
The selected language is saved.
The pump switches of
f automatically.
The pump restarts automatically and displays the start screen with all parameters
(pos. 4). After approx. 5 seconds the pump is ready for operation (pos. 5).
Start-up
136417102276 Rev. 5-02.2020
To Next Page
Loading...
Need help?
General
