7.10.11 Service interval
Here you can select the time after which a request to carry out maintenance is to be
shown in the display
.
NOTICE!
When a metering chemical is selected from the database, a resistance
check of the pump materials is stored in connection with the chemicals and
the corresponding service interval is set automatically
.
When a custom metering chemical is defined or set, the resistance must be
checked using the pump materials given on the pump info screen and the
corresponding service interval set.
Fig. 63: Configuration: Service interval
Factory setting: No service
[Service interval] - setting:
1.
[Call up the Main menu] :
Ä
Chapter 7.7 ‘Main menu’ on page 73
2.
[Select Configuration] - setting:
Ä
Chapter 7.10 ‘Overview - Configuration’
on page 92
3. Use the scrollbar to scroll to the [Service interval]
.
4. [Select Service interval] .
5. Select the required interval:
The following intervals can be set:
n No service
n 13 weeks = quarterly
n 26 weeks = semi-annually
n 52 weeks = annually
n variable = any setting
Ä
Chapter 7.10.11.1 ‘[Service interval] - [Variable]’ on page 113
6.
By pressing the button, you can return to the [main menu].
7.
By pressing the button, you can return to the [operating display].
Control / Software
112417102276 Rev. 5-02.2020
To Next Page
Need help?
General
