7.9.5 [Operating mode] [T
imer]
In the Timer operating mode, the runtime and standstill times of the pumps are determined
by the adjustable time spans. There are two different program types for selection here.
In the seven-day programme, up to seven metering times can be set per weekday.
Switch-on time, metering duration and metering capacity can be individual selected for
each metering time.
With the interval programme, the pump works with a continuously repeating sequence of
set switch-on duration and switch-off duration.
The following timer settings can be selected:
n ‘Seven-day programme
’:
Ä
Chapter 7.9.5.1 ‘[Operating mode] - [Timer] [Select Seven-day programme] .’
on page 89.
The ‘Seven-day programme’ starts metering at selected metering times.
Seven metering times per weekday / metering duration and metering
capacity can be selected separately for each metering.
n ‘Interval programme’:
Ä
Chapter 7.9.5.2 ‘[Operating mode] [Timer] [Set Interval programme] .’ on page 91.
In the ‘Interval programme’ the pump runs and pauses for the duration of
the set switch-on and switch-off times. The process is repeated
continuously
, whereby the switch-on time, switch-off time and metering
capacity can be selected.
7.9.5.1 [Operating mode] - [Timer] [Select Seven-day programme] .
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
19
20
Fig. 42: [Timer] [Seven-day programme]
Control / Software
89 417102276 Rev. 5-02.2020
To Next Page
Loading...
Need help?
General
