7.10.10 Metering chemical
Under the menu item “Metering chemical” a name for the metered chemical can be
entered and shown in the display
.
It is also possible to create a link between the Ecolab chemical stored in an internal
database and the pump software.
In this case, the pump can display whether the materials in the pump head are suitable for
the new chemical when the container is changed after entering the chemical name.
At the same time, a maintenance interval suitable for this chemical is suggested.
Overview
Fig. 59: Configuration: Metering chemical
Factory setting: No entry
The following selection options are available:
n
Ä
Chapter 7.10.10.1 ‘No entry’ on page 108
n
Ä
Chapter 7.10.10.2 ‘Manual input (manual)’ on page 109
n
Ä
Chapter 7.10.10.3 ‘Chemical selection from an integrated database’ on page 110
Control / Software
107 417102276 Rev. 5-02.2020
To Next Page
Loading...
