Switch on monitoring for diaphragm breakage:
Fig. 73: Switch on monitoring for diaphragm breakage
Factory setting: Monitoring for diaphragm breakage switched off
1.
[Call up the Main menu] :
Ä
Chapter 7.7 ‘Main menu’ on page 73
2.
[Select Configuration] :
Ä
Chapter 7.10 ‘Overview - Configuration’ on page 92
3. Use the scrollbar to scroll to the [menu item Diaphragm breakage] .
4. [Select Diaphragm breakage] .
ð
Screen switches to the query ‘W
ith diaphragm breakage’.
5. If required, select ‘
With diaphragm breakage’ .
6.
Pressing the button saves the setting.
ð
The screen switches to the overview: [Configuration].
7.
By pressing the button, you can return to the [main menu].
8.
By pressing the button, you can return to the [operating display].
Control / Software
125 417102276 Rev. 5-02.2020
To Next Page
Loading...
Need help?
General
