WARNING!
Risk of slipping due to fluid in the operation and provisioning area!
–
Wear non-slip, chemically resistant shoes when working.
– Place product containers in a tank to prevent a slipping hazard caused
by leaking fluids.
ENVIRONMENT!
Immediately soak up any leaking liquids with a suitable binding agent and
dispose of properly
.
The following screens show example displays for a pump with capacity of
1
1 l/h. Specifications and information shown will differ for other pump sizes.
The container change is defined in the [Configuration] / [Empty signal], depending on the
preset (
Ä
Chapter 7.10.8 ‘Empty signal’ on page 103). The procedure differs depending
on whether ‘Acknowledge automatically’ or ‘Acknowledge manually’ was selected.
The container change is indicated by an orange flashing empty signal indicator
that
represents a reserve signal. This means that an empty signal should be anticipated in the
near future and that a container should be made available now
. The empty signal
itself
is displayed in red. The pump stops and the empty signal is lit continuously in red.
A container change is required after the empty signal.
Operation
142417102276 Rev. 5-02.2020
To Next Page
Loading...
Need help?
General
