Epson N6 Series - Page 216

Maintenance 4. Cable
204 N6 Rev.2
(4
5)
Remove the ground wire terminals.
Cross recessed binding head machine screw:
M4×8
(46)
Pull the following cables (connectors) to the
inside of the Arm #1.
Cables (connectors):
BAT_CN3, BAT_CN6, GS01,
LED_CN1
(47)
Cut
off the cable tie of the removed J2 cable
fixing plate.
Be careful not to lose the removed cable
fixing plate.
(48)
Cut off the cable tie that fixes the cable unit.
(49)
Remove the J1
cable fixing plate fixed on the
Arm #1.
Hexagon socket head cap bolts: 2-M4×8

NOTE