Epson WF-C5890 Series

The Position, Size, or Margins of the Copies are Incorrect
e
following causes can be considered.
The paper is loaded incorrectly.
Solutions
Load paper in the correct direction, and slide the edge guide against the edge of the paper.
The originals are not placed correctly.
Solutions
❏ Make sure the original is placed correctly against the alignment marks.
❏ If the edge of the scanned image is missing, move the original slightly away from the edge of the
scanner glass. You cannot scan the area within approximately 1.5 mm (0.06 in.) from the edge of the
scanner glass.
& “Placing Originals” on page 147
There is some dust or stains on the scanner glass.
Solutions
Clean the scanner glass and the document cover using a dry, so, clean cloth. If there is dust or stains
around the originals on the glass, the copy area may extend to include the dust or stains, resulting in the
wrong copying position or small images.
& “Cleaning the Scanner Glass” on page 266
The size of the paper is set incorrectly.
Solutions
Select the appropriate paper size setting.
Original Size is wrong in copy setting.
Solutions
Select the appropriate Original Size in the copy setting.
Solving Problems > Printing, Copying, Scanning, and Faxing Quality is Poor > Copy Quality is Poor
318