Epson WF-C5890 Series

3. Select in the following order.
Network Security tab > IPsec/IP Filtering > Client Certicate
4. Import the certicate in Client Certicate.
If you have already imported a certicate published by a Certication Authority, you can copy the certicate
and use it in IPsec/IP Filtering. To copy, select the
certicate
from Copy From, and then click Copy.
Related Information
& “Default Value of the Administrator Password” on page 19
& “Conguring a CA-signed Certicate” on page 453
& “Conguring a CA Certicate” on page 458
Connecting the Printer to an IEEE802.1X Network
Conguring an IEEE802.1X Network
When you set IEEE802.1X to the printer, you can use it on the network connected to a RADIUS server, a LAN
switch with authentication function, or an access point.
TLS version 1.3 does not support this function.
1.
Enter the printer's IP address into a browser to access Web Cong.
Enter the printer's IP address from a computer that is connected to the same network as the printer.
You can check the IP address of the printer from the following menu.
Settings > General Settings > Network Settings > Network Status > Wired LAN/Wi-Fi Status
2. Enter the administrator password to log in as an administrator.
3. Select in the following order.
Network Security tab > IEEE802.1X > Basic
4. Enter a value for each item.
If you want to use the printer on a Wi-Fi network, click Wi-Fi Setup and select or enter an SSID.
Note:
You can share settings between Ethernet and Wi-Fi.
5. Click Next.
A conrmation message is displayed.
6. Click OK.
e printer is updated.
Related Information
& “Default Value of the Administrator Password” on page 19
Administrator Information > Network Security Settings > Connecting the Printer to an IEEE802.1X Network
473