Freescale Semiconductor FlexRay MFR4310 - Appendix A Electrical Characteristics; General; Parameter Classification

MFR4310 Reference Manual, Rev. 2
Freescale Semiconductor 237
Appendix A
Electrical Characteristics
A.1 General
NOTE
The electrical characteristics given in this appendix are preliminary and
must be used as a guide only. Values cannot be guaranteed by Freescale and
are subject to change without notice.
NOTE
The part is specified and tested over the 5 V and 3.3 V ranges. For the
intermediate range, generally the electrical specifications for the 3.3 V
range apply, but the part is not tested in production test in the intermediate
range.
This appendix provides the most accurate electrical information for the MFR4310 device available at the
time of publication.
This introduction is intended to give an overview on several common topics like power supply, current
injection etc.
A.1.1 Parameter Classification
The electrical parameters shown in this supplement are guaranteed by various methods. The following
classifications are used and the parameters are tagged accordingly in the column labeled C in the parameter
tables, where appropriate.
P: Parameters that are guaranteed during production testing on each individual device.
C: Parameters that are achieved by the design characterization by measuring a statistically relevant
sample size across process variations.
T: Parameters that are achieved by design characterization on a small sample size from typical
devices under typical conditions unless otherwise noted. All values shown in the typical column
are within this category.
D: Parameters that are derived mainly from simulations.