Freescale Semiconductor FlexRay MFR4310 - Figure 3-13. CHI Error Flag Register (CHIERFR); Table 3-21. CHIERFR Field Descriptions

FlexRay Module (FLEXRAYV4)
MFR4310 Reference Manual, Rev. 2
86 Freescale Semiconductor
3.3.2.14 CHI Error Flag Register (CHIERFR)
This register holds the CHI related error flags. The application can clear each error flag by writing a 1 to
it. Writing a 0 does not change the state of the flag. The interrupt generation for each of these error flags
is controlled by the CHI interrupt enable bit CHIE in the Global Interrupt Flag and Enable Register
(GIFER).
11–8
SSI[3:0]_IE
Slot Status Counter Incremented Interrupt Enable — This bit controls SSI[3:0]_IF interrupt request
generation.
0 interrupt request generation disabled
1 interrupt request generation enabled
5
EVT_IE
Even Cycle Table Written Interrupt Enable — This bit controls EVT_IF interrupt request generation.
0 interrupt request generation disabled
1 interrupt request generation enabled
4
ODT_IE
Odd Cycle Table Written Interrupt Enable — This bit controls ODT_IF interrupt request generation.
0 interrupt request generation disabled
1 interrupt request generation enabled
0x0020 Write: Normal Mode
1514131211109876543210
R
FRLB_EF FRLA_EF
PCMI_EF
FOVB_EF
FOVA_EF
MBS_EF
MBU_EF
LCK_EF DBL_EF
SBCF_EF
FID_EF
DPL_EF
SPL_EF
NML_EF
NMF_EF ILSA_EF
W
Reset0000000000000000
Figure 3-13. CHI Error Flag Register (CHIERFR)
Table 3-21. CHIERFR Field Descriptions
Field Description
15
FRLB_EF
Frame Lost Channel B Error Flag — This flag is set if a complete frame was received on channel B but could
not be stored in the selected individual message buffer because this message buffer is currently locked by the
application. In this case, the frame and the related slot status information are lost.
0 No such event
1 Frame lost on channel B detected
14
FRLA_EF
Frame Lost Channel A Error Flag — This flag is set if a complete frame was received on channel A but could
not be stored in the selected individual message buffer because this message buffer is currently locked by the
application. In this case, the frame and the related slot status information are lost.
0 No such error
1 Frame lost on channel A detected
13
PCMI_EF
Protocol Command Ignored Error Flag — This flag is set if the application has issued a POC command by
writing to the POCCMD field in the Protocol Operation Control Register (POCR) while the BSY flag is equal to
1. In this case the command is ignored by the FlexRay module and is lost.
0 No such error
1 POC command ignored
Table 3-20. PIER1 Field Descriptions (Continued)
Field Description