Device Overview
MFR4310 Reference Manual, Rev. 2
40 Freescale Semiconductor
D[15:8] are data signals of the AMI/MPC interface. D15 is the MSB of the AMI/MPC data bus.
PB[0:7] are HCS12 interface multiplexed address/data signals in the HCS12 Host interface mode of
operation. PB0 is the LSB of the HCS12 address/data bus.
2.4.3.7 D[7:0]/PA[0:7] — AMI/MPC Data Bus, HCS12 Multiplexed Address/Data
Bus
D[7:0]/PA[0:7] are general purpose input or output pins. Their functions are selected by the IF_SEL[1:0]
pins. Refer to Section 2.7, “External Host Interface” for more information. These pins can be configured
to provide high or reduced output drive, and also to enable or disable pullup or pulldown resistors on the
pins.
D[7:0] are data signals of the AMI/MPC interface. D0 is the LSB of the AMI/MPC data bus.
PA[0:7] are HCS12 interface multiplexed address/data signals in the HCS12 Host interface mode of
operation. PA7 is the MSB of the HCS12 address/data bus.
2.4.3.8 CE#/LSTRB — AMI/MPC Chip Select, HCS12 Low-byte Strobe
The function of this pin is selected by IF_SEL[1:0] pins. Refer Section 2.7, “External Host Interface” for
more information. The pin can be configured to enable or disable a pullup or pulldown resistor on the pin.
CE# is an AMI/MPC interface transfer size input signal. It indicates the size of the requested data transfer
in the current bus cycle.
LSTRB is an HCS12 interface low-byte strobe input signal. It indicates the type of bus access.
2.4.3.9 WE#/RW_CC# — AMI Write Enable, HCS12 Read/Write Select
The function of this pin is selected by the IF_SEL[1:0] pins. Refer to Section 2.7, “External Host
Interface” for more information. The pin can be configured to enable or disable a pullup or pulldown
resistor on the pin.
WE# is an AMI interface write select signal. It strobes the valid data provided by the host on the D[15:0]
pins during write operations to the MFR4310 memory.
RW_CC# is an HCS12 interface read/write input signal. It indicates the direction of data transfer for a
transaction.
2.4.3.10 A10/ECLK_CC — AMI/MPC Address Bus, HCS12 Clock Input
The function of this pin is selected by the IF_SEL[1:0] pins. Refer Section 2.7, “External Host Interface”
for more information. The pin can be configured to enable or disable a pullup or pulldown resistor on the
pin.
A10 is an AMI/MPC interface address signal.
ECLK_CC is the HCS12 interface clock input signal. (The maximum frequency of this signal can be
calculated from the ECLK_CC pulse width low and high times, t
LEC
and t
HEC
given in Table A-15.)
To Next Page
Loading...