Error Code
449
Problem Solving
14
035-746
O [Cause] The fax network does not respond.
This may be caused by the following. Check them and
then send the fax again.
[Remedy] Is the telephone line correctly connected?
You may not have a fax network contract, or the fax
network may have a problem.
When connecting the machine to the fax network, enter
two pauses after "161" and "162", then dial the telephone
number.
035-747
035-748
O [Cause] The dialing or transmission was interrupted by the <Stop>
button.
[Remedy] No action is necessary.
035-749
O [Cause] The number was re-dialed the specified number of times,
but the destination machine did not respond.
[Remedy] Ask the recipient if the telephone number is correct or if
the telephone line and telephone switchboard for the
destination machine are defective.
035-750
O [Cause] An error occurred during fax transmission.
[Remedy] Check the settings and the phone number, and send the
fax again. If the error persists, contact our Customer
Support Center.
035-751
035-752
O [Cause] The dialing or transmission was interrupted by the <Stop>
button.
[Remedy] No action is necessary.
035-753
O [Cause] Memory became insufficient when attempting to receive
more than 999 pages of fax document.
[Remedy] Ask the sender to reduce the number of pages at one
transmission.
035-754
035-755
035-756
035-757
035-758
035-759
035-760
035-761
O [Cause] An error occurred during fax transmission.
[Remedy] Turn the machine off and on. If the error persists, contact
our Customer Support Center.
Error Code
Category
Cause and Remedy
CPFSMO
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
To Next Page
Loading...
Need help?
General
