RX100 S8
Upgrade and Maintenance Manual 107
Power supply
6.4.1 Preliminary steps
Ê "Disabling BitLocker functionality" on page 63
Ê "Shutting down the server" on page 45
Ê "Disconnecting the server from the mains" on page 46
Ê "Getting access to the component" on page 47
6.4.2 Removing the standard power supply unit
Ê Remove the power supply unit as described in section "Removing the
defective standard power supply unit" on page 93.
Figure 36: Removing the adapter plate
Ê Remove the screw (see circle) which attach the adapter plate of the power
supply unit to the housing.
Ê Push the adapter plate a few centimeters inward to detach it from the two
bolts (see close-ups).
Ê Remove the adapter plate.
To Next Page
Loading...
Need help?
General