212 Upgrade and Maintenance Manual
RX100 S8
Processor
11.1 Basic information
11.1.1 Supported processors
– one Intel
®
Quad-Core Xeon E3-12xxv3 or one Dual Core i3-4xxx or one
Dual Core Pentium G3xxx processor
– one processor socket LGA 1150
I For system relevant information, refer to your server’s hardware
configurator available online at the following address:
for the EMEA market:
http://ts.fujitsu.com/products/standard_servers/index.htm
for the Japanese market:
http://jp.fujitsu.com/platform/server/primergy/system/
11.2 Replacing the processor
V CAUTION!
Processors are modules which are extremely sensitive to electrostatic
discharges and therefore must always be handled with care. After a
processor has been removed from its protective sleeve or from its
socket, place it with its smooth side down on a non-conducting, antistatic
surface. Never push a processor over a surface.
Field Replaceable Unit
(FRU)
Hardware: 15 minutes
Software: 5 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
To Next Page
Loading...
