RX100 S8
Upgrade and Maintenance Manual 55
Basic hardware procedures
4.5.3 Sliding the server into the rack
Figure 9: Sliding the server into the rack
Ê Release the locking mechanism of both rails (1).
Ê Push the server as far as it will go into the rack (2) until the quick-release
levers engage (3).
V CAUTION!
Be careful with your fingers. You can pinch them when the quick-
release levers change to the release position.
Ê Reconnect all cables except the power cord to the server rear.
4.6 Connecting the server to the mains
V CAUTION!
The server supports a mains voltage in the range of 100 V - 240 V. You
may only operate the server if its rated voltage range corresponds to the
local mains voltage.
í–²
í–´
í–³
í–³
To Next Page
Loading...
Need help?
General