Fujitsu PRIMERGY RX100 S8 - Page 292

292 Upgrade and Maintenance Manual RX100 S8
Appendix
7
Power-on
indicator
off
is off in the following case:
– the system is in power-off mode but
connected to the mains (AC
connected)
green on
is on in the following cases:
– the system has been switched on and
is in power-on delay
– the system is powered on and in
normal operation (S0)
flashes slowly
(1/2 Hz)
iRMC S4 is not ready
V CAUTION!
This description for the behavior of the power-on
indicator is only valid for systems with iRMC FW
7.3.xF and higher!
8
Power-off
indicator
(AC
connected)
green on
is on in the following cases:
– the system is in power-off mode but
connected to the mains (AC
connected)
– the system has been switched on and
is in power-on delay
I After connecting the server to the
mains it takes about 60 seconds
until the server enters the standby
mode.
off
is off in the following cases:
– the system is not connected to the
mains
– the system is powered on and in
normal operation (S0)
Pos. Indicator Status Description