Operation
5.8.2.5.2 Antenna Speed Selection Control from the ACU
The [SHIFT] key toggles between track (low) speed and slew (high). POL is one
speed and therefore the [SHIFT] key has no effect on its speed.
To operate the antenna manually, use the following procedures:
1. From the Main menu, select Tracking functions... and then Manual antenna
control.
NOTE: In the following steps, the respective field is highlighted
to indicate commanded speed and direction.
2. To move the AZ axis at track speed, press the left arrow key to move the axis
CCW and the right arrow key to move it CW. To move the axis at slew speed,
hold down the [SHIFT] key and the left arrow key to move the antenna CCW,
and the right arrow key to move it CW.
3. To move the EL axis at track speed, press the up arrow key to move the axis
upward and the down arrow key to move it downward. To move the axis at
slew speed, hold down the [SHIFT] key and the up arrow key to move the
antenna upward, and the down arrow key to move it downward.
4. To rotate the POL axis, press the CCW arrow key or the CW arrow key
5.8.2.6 Edit a New or Existing Target Menu
The Edit a new or existing target… menu allows the user to configure up to 50
targets for the target-oriented environment to establish a target-specific data base
for any predictive or programmed tracking data relative to the target.
This menu contains the target selection menu and the following parameters and
menu:
• Target name
• Erase target name
• Tracking mode
• Edit target parameters...
The target selection menu appears as either 25 blank lines (to denote the capability
to configure targets -- this menu contains two screens, each with 25 initialized or
non-initialized targets), names of any preconfigured targets, or a combination of
blank lines and named targets. Refer to the following sections to name a target,
erase a target name, change the tracking mode of a target, or to edit a target's
parameters.
5-19
To Next Page
Loading...
Need help?
General