General Dynamics 7200 - Target Editing Changes

CP/LP PATH Option Notes
Target Editing Changes:
Modify current target…
Set feed mode…
Add “Feed path”
ITEMTITLE= " Feed path"
MACNAME= FEEDPATH
OPERATOR =SECURE
Help
These parameters set the path for RX and TX.
For each selection:
Path 1 = LCP or VLP
Path 2 = RCP or HLP
Format: RX: xxx/xxx TX: xxx/xxxx
Where: xxx/xxx is LCP/VLP or RCP/HLP
All target tracking modes also support the path selection.
Edit a new or existing target…
Target selection…
Edit target parameters…
Feed path RX: xxx/xxx TX: xxx/xxx
Where: xxx/xxx is LCP/VLP or RCP/HLP
ITEMTITLE= " Feed path"
MACNAME= TRGFEEDPATH
TARGET_SECURE =SECURE
Description:
These parameters set the path for RX and TX.
For each selection:
Path 1 = LCP or VLP
Path 2 = RCP or HLP
L-2