Operation
5.8.4 Set User Level (and Passwords) Menu
Set User Level (and Passwords) Menu contains the following functions:
• Go to monitor level
• Go to operator level
• Go to supervisor level
• Change operator password
• Change supervisor password
5.8.4.1 7200 ACS User Levels
The 7200 ACS has three user levels:
• Monitor level: At Monitor level, the user can examine all system parameters
but cannot edit the parameters or command the antenna.
• Operator level: At Operator level, the user can command the antenna to a
new target or use manual mode, but cannot edit system parameters.
• Supervisor level: At Supervisor level, there are no restrictions on the user --
the user may modify any system parameters or target configurations.
To change the user level of the system, use the following procedures:
1. From the Main menu, select Set user level (and passwords)....
2. Select the desired level and press [ENTER].
5.8.4.2 7200 ACS Passwords
No password is required to change the user level of the system to Monitor, but
passwords are required to change to either the Operator or Supervisor level.
Passwords are one to nine digits (0 through 9). Setting a password to 0 disables
password protection for that level. Supervisor level is required to change
passwords at Operator or Supervisor levels.
If password protection is not desired, disable passwords (set the password to 0),
and set the user level to Supervisor. The user level is stored in battery-backed
memory and will be retained by the ACU until it is changed.
For instructions on disabling or changing passwords through the system hardware,
refer to Appendix B.
5-36
To Next Page
Loading...
Need help?
General