Operation
To change an Operator password, use the following procedures:
1. From the Main menu, select Set user level (and passwords)....
2. Select Change operator password and press [ENTER]. If the system is not at
Supervisor level, a prompt will appear to notify the user to go to Supervisor
level (refer to Section 5.8.4.1).
3. The following prompt will appear:
Enter new password to go to operator level: ___________
4. Enter the desired password (one to nine digits, 0 to 9) and press [ENTER].
5. The following prompt will appear: Re-enter password:
6. Re-enter the password exactly as it was originally entered. If the password is
incorrectly entered, the following prompt will appear: Password entered
differently; try again
7. If the password is entered incorrectly again, the system will return to the
Change user level screen.
To change a Supervisor password, select Change supervisor password, and follow
steps 3 through 7 above.
5.8.5 Display System Status Menu
This menu contains the following parameters:
• Position loop diagnostics
Steptrack statistics
Serial DTR Diagnostics
• Firmware version information
These functions are not normally used in everyday operation, but are useful in
debugging the 7200 ACS, especially during installation.
5-37
To Next Page