Operation
7. The 4-axis system has a 4TH AXIS that is part of the Feed Assembly. Since
many different versions of the feed arrangement exist, additional information
will be supplied as needed.
8. Press the RESET button located on the Digital Operator console to clear any
faults detected by the motor controllers (inverters). Refer to Section 4.4.1.2.1.
9. Return MAINT/REMOTE switch to REMOTE.
5.7.2 Manual Movement From the ACU
Refer to Section 5.8.2.5 for instructions on manually controlling the antenna from
the ACU.
5.8 The 7200 ACS Main Menu
All operation of the 7200 ACU is through the Main Menu. See Appendix G for
7200 menu tree flow charts. The Main Menu gives the operator a choice to select
a function for the 7200 ACU to perform or to select another menu where more
functions are available or where parameters can be changed.
For example, the Main menu has three functions: Return to standby (stop
tracking), Clear/correct system faults and Redraw the display. It also has four
menus:
• Tracking functions...
• Set user level (and passwords)...
• Display system status...
• Edit system configuration...
Figure 5-7 shows a representation of the Main menu screen as it appears on the
7200 ACU display.
Figure 5-7 7200 ACU Main Menu Screen
5-8
To Next Page
Loading...
Need help?
General