Operation
5.8.2.6.3.4 Move to Longitude Tracking Mode Parameters
The Move to longitude parameters are described in Table 5-13.
TABLE 5-13 MOVE TO LONGITUDE PARAMETERS
PARAMETER DEFAULT DESCRIPTION
E. Longitude of target [deg] N/A E. longitude of target to which antenna will move
(Look angles [deg]) N/A
Read-only item that shows look angles
corresponding to the E. Longitude of target [deg]
Polarization [deg] N/A POL look angle for target
Bias angles [deg] N/A
Added to Look angles [deg]) to compute target
position; these exist because look angles can be
edited only at Supervisor level; Operator level can
edit the Bias angles [deg]
5.8.2.6.3.5 Move to Look Angles Tracking Mode Parameters
Table 5-14 describes the Move to look angles parameters.
TABLE 5-14 MOVE TO LOOK ANGLES PARAMETERS
PARAMETER DEFAULT DESCRIPTION
Look angles [deg] N/A
Look angles to which the antenna will move when selected
target is tracked.
Bias angles [deg] N/A
These angles are added to the look angles to determine the
target position. These exist because the look angles can only be
edited at Supervisor level, but the bias angles can be edited at
Operator level, allowing periodic repeaking of the target without
losing the base position.
5-29
To Next Page
Loading...