CP/LP PATH Option Notes
M&C support
The “MT M&C” support is for Path selection is provided by parameter MACNAMEs
listed above.
The Path status is provided as part of the existing “G” Keyword.
G [F] -- returns global system status.
Arguments: F (optional): transmit full status report
Default: transmit only changes since last G command.
1 2 3 4 5 6 7 8
123456789^123456789^123456789^123456789^123456789^123456789^123
456789^123456789^123456
AXaaaaaaYaaaaaaZaaaaaaS+nnnTnnMaabbHnBhhhPnUmnCXaaaaaaYaaaaaaZaaa
aaaFhhhRFnnnnnnnnAnnnInCn
G.B returns changes in feed status of CP/LP and PATH states.
The “B” status falls between H (happy flag) and P (program track status)
Returns three hex digits (FFF), bit-mapped:
Bit 0: 1 = SW4 RX LP
Bit 1: 1 = SW4 RX CP
Bit 2: 1 = SW3 RX LP
Bit 3: 1 = SW3 RX CP
Bit 4: 1 = SW1 RX LV
Bit 5: 1 = SW1 RX RH
Bit 6: 1 = SW6 TX LP
Bit 7: 1 = SW6 TX CP
Bit 8: 1 = SW5 TX LP
Bit 9: 1 = SW5 TX CP
Bit 10: 1 = SW2 TX LV
Bit 11: 1 = SW2 TX RH
This status is unique to CP/LP-path and replaces the standard CP/LP status.
The “RC M&C” support for path selection and control is provided by use of current
CP/LP commands and with the addition of a new command for switch status and
path control.
Pre-existing CP/LP commands used are:
L-3
To Next Page
Loading...
Need help?
General