General Dynamics 7200 - Three Axis System (if Applicable); Four Axis System (if Applicable)

SITE TEST PROCEDURE
F - 7
3. a. Drive the antenna using the JOG EL UP switch until the
limit switch stops the movement of the antenna. _______(Check)
b. Check the 7200 ACU display for a SUM LIMIT message. _______(Check)
c. Record the EL angle at which the limit occurred. ______(Record)
d. Verify that the antenna will drive in the DOWN direction. _______(Check)
4. a. Drive the antenna using the JOG EL DOWN switch until
the limit switch stops the movement of the antenna. _______(Check)
b. Check the 7200 ACU display for a SUM LIMIT message. _______(Check)
c. Record the EL angle at which the limit occurred. ______(Record)
d. Verify that the antenna will drive in the UP direction. _______(Check)
THREE AXIS SYSTEM (IF APPLICABLE)
5. a. Drive the antenna using the JOG POL CW switch until the
limit switch stops the movement of the antenna. _______(Check)
b. Check the 7200 ACU display for a SUM LIMIT message. _______(Check)
c. Record the POL angle at which the limit occurred. ______(Record)
d. Check that the feed will drive in the CCW direction. _______(Check)
6. a. Drive the antenna using the JOG POL CCW switch until
the limit switch stops the movement of the antenna. _______(Check)
b. Check the 7200 ACU display for a SUM LIMIT message. _______(Check)
c. Record the POL angle at which the limit occurred. ______(Record)
d. Check that the feed will drive in the CW direction. _______(Check)
FOUR AXIS SYSTEM (IF APPLICABLE)
5. a. Drive the antenna using the JOG 4th Axis CW switch until
the limit switch stops the movement of the antenna. _______(Check)
b. Check the 7200 ACU display for a SUM LIMIT message. _______(Check)
c. Record the 4th Axis angle at which the limit occurred. ______(Record)
d. Check that the feed will drive in the CCW direction. _______(Check)
6. a. Drive the antenna using the JOG 4th Axis CCW switch until
the limit switch stops the movement of the antenna. _______(Check)
b. Check the 7200 ACU display for a SUM LIMIT message. _______(Check)
c. Record the 4th Axis angle at which the limit occurred. ______(Record)
d. Check that the feed will drive in the CW direction. _______(Check)