Operation
To edit any of the parameters under this menu, use the following procedures.
1. From the Main menu, select Edit system configuration... and then select
RF/geometry....
2. To change Polarization axis or Antenna droop correction, use the arrow keys to
move the cursor to the parameter to be edited and press [ENTER]. Using the up
and down arrow keys, toggle through the preprogrammed choices. When the
desired choice is highlighted, press the [ENTER] key.
3. To change any of the remaining parameters, use the arrow keys to move the
cursor to the parameter to be edited and press [ENTER]. Using the numeric
keys, enter a value within the range specified in the system prompt and press
[ENTER].
4. Press the [PRIOR] key and the following prompt appears:
Save changes to menu "RF/geometry"? (yes/no)
[YES/NO] changes YES/NO response. [ENTER] accepts displayed YES/NO
response.
5. To save the changes, toggle the YES/NO key to YES and press [ENTER].
5-68
To Next Page
Loading...