SITE TEST PROCEDURE
F - 19
TRACKING RESTORATION OPTIONS
Standby after boot (enabled, disabled)
Standby on emergency stop (enabled,
disabled)
Standby on motor controller fault (enabled, disabled)
Standby on maintenance override (enabled, disabled)
Standby on ADU power loss (enabled, disabled)
Tracking initiation delay (ms)
MESSAGE PRINTER OPTIONS
Target Change/Standby (enabled, disabled)
Faults (enabled, disabled)
New Steptrack Peak (enabled, disabled)
New OPT Solution (enabled, disabled)
Parameter Changes (enabled, disabled)
User Level Changes (enabled, disabled)
System Clock Set (enabled, disabled)
Tracking signal modified (enabled, disabled)
Target Scheduler Status (enabled, disabled)
Initialization messages (enabled, disabled)
Tag w/ Current Position (enabled, disabled)
Execution Trace (enabled, disabled)
A – Fixed remote port table M. Neely 8-14-06 D. Harrison 8-14-06 6695
New Release, (from CG-1260-) M. Neely 6-25-02 D. Harding 6-25-02 4137
Rev. No/change Revised By Date Approved By Date ECO#
To Next Page
Loading...