CP/LP PATH Option Notes
L-6
SW6 TXLP = Switch 6 in LP position
“Display system status…’
“Hardware diagnostics…”
“Output states…”
Status of commands to the CP/LP-PATH controller are displayed in the “Output
states”
Switch indications displayed are:
LP_CMD = Command feed to LP configuration
CP_CMD = Command feed to CP configuration
TX-P2-CMD = Command TX to RCP/HLP path
TX-P1-CMD = Command TX to LCP/VLP path
RX-P2-CMD = Command RX to RCP/HLP path
RX-P1-CMD = Command RX to LCP/HLP path
To Previous Page
Loading...