Hioki 3153 - Page 202

189
_____________________________________________________________________________________________
10.3 RS-232C Command Reference
______________________________________________________________________________________________
Syntax
:CONFigure:INSulation:TIMer?
Response
syntax
<data>
<data>
0.3 to 999
(NR1 or NR2)
Function
Queries the test time (unit: s) for insulation-resistance tests.
Example
Queries the test time for insulation-resistance tests.
Transmission :CONFigure:INSulation:TIMer?
Response 10.0
The test time is set to 10.0 s.
Syntax
:CONFigure:INSulation:DELay <data>
<data>
0.1 to 99.9
(NR1 or NR2)
Function
Sets the delay time (unit: s) for insulation-resistance tests in the READY state.
Example
Sets the delay time for insulation-resistance tests at 3.0 s.
Transmission :CONFigure:INSulation:TIMer 3.0
Error
The execution of this command in a state other than the READY state or "test setting state"
causes an execution error.
Syntax
:CONFigure:INSulation:DELay?
Response
syntax
<data>
<data>
0.1 to 99.9
(NR2)
Function
Queries the delay time (unit: s) for insulation-resistance tests.
Example
Queries the delay time for insulation-resistance tests.
Transmission :CONFigure:INSulation:DELay?
Response 3.0
The set test time is 3.0 s.
:CONFi
g
ure:INSulation:TIMer?
Queries the test time for insulation-resistance tests.
:CONFi
g
ure:INSulation:DELa
y
Sets the delay time for insulation-resistance tests.
:CONFi
g
ure:INSulation:DELa
y
?
Queries the delay time for insulation-resistance tests.