HP 8920A - Page 622

Index
622
view of, 122
AMPS-TACS
control channel decoder, 271
forward control channel, 355
forward voice channel, 355
radio standard, 366
reverse control channel, 276
reverse voice channel, 276
simulated system, 136
voice channel decoder, 271
AMPS-TACS decoder mode
AF Anl In, 272
Arm Meas, 272
Channel, 272
Data (hex), 273
Gate Time, 273
Input Level, 273
Num of Bits, 274
Polarity, 274
Single/Cont, 275
Stop Meas, 275
Trig Level, 275
Trigger Pattern (bin), 275
view of, 271
AMPS-TACS encoder mode
AFGen2 To, 356
Audio Out, 356
B/I Delay, 357
Bursts, 357
Busy/Idle, 357
Channel, 357
Data Level, 357
Data Rate, 358
Filler, 359
FM Coupling, 360
Message, 361, 362
Polarity, 364
SAT Freq, 365
SAT Level, 365
Send, 365
Send Filler, 365
Send Mode, 366
Standard, 366
Stop, 366
Stop Filler, 366
view of, 355
Analog Meas screen
AF Anl In, 244
AF Freq, 245
AFGen1 Freq, 245
AFGen1 To, 245
Amplitude, 245
De-Emphasis, 245
Detector, 246
Filter 1, 246
Filter 2, 246
FM Deviation, 246
TX Freq Error, 246
TX Power, 246
view of, 244
analog meter, 62
analyzer
arming measurements, 275, 283, 288,
292, 297, 303, 308, 320, 337
calibration, 518
disarming measurements, 297
frequency, markers, 514
input port, 508
level, markers, 514
analyzer, AF
CDCSS decoder settings, 284
input, 272, 280, 285, 289, 295, 301,
305, 317, 335
level, 273, 282, 287, 291, 296, 302,
306, 319, 336
analyzer, RF
frequency, 351, 479, 558
input attenuation, 475
input port, 476
level, 473
measurements, 478
sensitivity, 477
tuning, 351, 479, 558
ANT IN connector
avoiding damage, 58, 95, 112, 349,
352, 476, 480, 508, 557, 559, 562
connecting to, 40, 508
description, 562
for ACP ratio measurements, 91, 95
for off-the-air measurements, 95, 310,
349, 476, 557
for RF measurements, 95, 349, 476,
557
gain at, 255
input attenuation, 94, 475, 515
loss at, 255
sensitivity, 477, 517
Antenna In
Configure screen, 255
Area #
Signaling Encoder screen, NMT mode,
423
Area 1
Signaling Encoder screen, LTR mode,
397
Area 2
Signaling Encoder screen, LTR mode,
397
arm
measurment, 272, 275, 281, 283, 285,
288, 289, 292, 296, 297, 302, 303,
305, 308, 320, 335, 337
radio interface interrupt, 461
Arm Meas
Signaling Decoder screen, AMPS-
TACS mode, 272
Signaling Decoder screen, CDCSS
mode, 281
Signaling Decoder screen, Digi Page
mode, 285
Signaling Decoder screen, DTMF
mode, 289
Signaling Decoder screen, EDACS
mode, 296
Signaling Decoder screen, Func Gen
mode, 302
Signaling Decoder screen, LTR mode,
305
Signaling Decoder screen, NAMPS-
NTACS mode, 272
Signaling Decoder screen, Tone Seq
mode, 335
arrow down key, 581
arrow left key, 583
arrow up key, 581
ASCII terminal, 86
configuring, 442
ASSIGN, 82, 83
Atten Hold
Duplex Test screen, 345
RF Generator screen, 488
RX Test screen, 498
attenuation
automatic control, 94, 475, 515