PIM hello interval: 30 s
PIM LAN delay (negotiated): 500 ms
PIM LAN delay (configured): 500 ms
PIM hello override interval (negotiated): 2500 ms
PIM hello override interval (configured): 2500 ms
PIM Silent: disabled
PIM neighbor tracking (negotiated): disabled
PIM neighbor tracking (configured): disabled
PIM generation ID: 0X161C232F
PIM require-GenID: disabled
PIM hello hold interval: 105 s
PIM assert hold interval: 3600 s
PIM triggered hello delay: 5 s
PIM J/P interval: 60 s
PIM J/P hold interval: 210 s
PIM state-refresh processing: enabled
PIM state-refresh interval: 10 s
PIM graft retry interval: 10 s
PIM state-refresh capability on link: capable
PIM BFD: disabled
PIM dr-switch-delay timer : not configured
Number of routers on link not using DR priority: 0
Number of routers on link not using LAN delay: 0
Number of routers on link not using neighbor tracking: 1
Run the display pim control-message counters command, and you can view the number of
PIM control messages.
<Quidway> display pim control-message counters
VPN-Instance: public net
PIM global control-message counters:
Received Sent Invalid
Register 0 0 0
Register-Stop 0 0 0
Probe 0 0 0
C-RP 0 0 0
PIM control-message counters for interface: Vlanif15
Received Sent Invalid
Assert 0 0 0
Graft 0 0 0
Graft-Ack 0 0 0
Hello 0 40 0
Join-prune 0 0 0
State-Refresh 0 0 0
BSR 0 0 0
3.8 Setting the Parameters of State-Refresh Messages
This section describes how to set the parameters of PIM-DM State-Refresh messages.
3.8.1 Establishing the Configuration Task
3.8.2 Enabling State-Refresh
3.8.3 Setting the Interval for Sending State-Refresh Messages
3.8.4 Setting the Timeout Interval for Receiving State-Refresh Messages
3.8.5 Setting the TTL Value of a State-Refresh Message
3.8.6 Checking the Configuration
3.8.1 Establishing the Configuration Task
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast 3 PIM-DM Configuration
Issue 01 (2009-07-28) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3-17
To Next Page
Loading...
