Huawei Quidway S9300

Data Preparation
To configure an interface to be PIM silent, you need the following data.
No. Data
1 Number of the interface connected to a host
4.14.2 Configuring PIM Silent
Context
PIM silent protects S9300s against PIM Hello message attacks.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
On the S9300, VLANIF interfaces and loopback interfaces support PIM.
Step 3 Run:
pim silent
PIM silent is enabled.
NOTE
The PIM silent and PIM BFD functions cannot be enabled at the same time.
----End
4.14.3 Checking the Configuration
Prerequisite
The configuration of PIM silent is complete.
Procedure
l Run the display pim interface [ interface-type interface-number | up | down ]
[ verbose ] command to check the PIM information on the interface.
----End
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast 4 PIM-SM Configuration
Issue 01 (2009-07-28) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4-47