Pre-configuration Tasks
Before setting the parameters for controlling a dynamic RP, complete the following tasks:
l Configuring the unicast routing protocol to ensure that IP routes between nodes are
reachable
l 4.4 Configuring Basic PIM-SM Functions
Data Preparation
To set the parameters for controlling a dynamic RP, you need the following data.
No. Data
1 Priority of a C-RP
2 Interval at which a C-RP sends
Advertisement messages
3 Timeout period during which a BSR waits
Advertisement message from a C-RP
4 Hash mask length of a C-BSR
5 Priority of a C-BSR
6 Interval at which a C-BSR sends Bootstrap
messages
7 Holdtime of a Bootstrap message from the
BSR
8 ACL that defines the range of addresses of
valid BSRs.
4.8.2 Changing the Values of C-RP Parameters
Context
Do as follows on the S9300 where the C-RP is configured.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
pim
The PIM view is displayed.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast 4 PIM-SM Configuration
Issue 01 (2009-07-28) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4-23
To Next Page
Loading...
Need help?
General
