2. Run:
msdp
The MSDP view is displayed.
3. Run:
peer peer-address sa-request-policy [ acl basic-acl-number ]
The rule for filtering received SA request messages is configured.
– peer-address: specifies the address of the MSDP peer that sends the SA request
message.
– basic-acl-number: specifies the filtering policy. If no ACL is specified, all SA
requests sent by the peer are ignored. If an ACL is specified, only the SA request
messages that meet the requirements are accepted.
----End
5.7.4 Configuring SA Caching
Context
Do as follows on the S9300 where an MSDP peer is configured.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
msdp
The MSDP view is displayed.
Step 3 Run:
cache-sa-enable
The SA caching is enabled.
By default, the SA caching is enabled. That is, after receiving an SA message, the S9300 caches
the (S, G) entries contained in the message.
Step 4 Run:
peer peer-address sa-cache-maximum sa-limit
The maximum number of (S, G) entries is set.
l peer-address: specifies the address of the remote MSDP peer.
l sa-limit: specifies the maximum number of (S, G) entries to be cached. The other entries are
discarded.
----End
5.7.5 Configuring the Rule for Filtering SA Messages
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast 5 MSDP Configuration
Issue 01 (2009-07-28) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-21
To Next Page
Loading...
