Total 2 entries matched
Run the display igmp ssm-mapping interface interface-type interface-number command, and
you can view information about SSM mapping on a specified interface.
<Quidway> display igmp ssm-mapping interface vlanif 3
IGMP SSM-Mapping is enabled
2.7 Maintaining IGMP
This section describes how to maintain IGMP.
2.7.1 Clearing the Information About an IGMP Group
2.7.2 Monitoring the Running Status of IGMP
2.7.3 Debugging IGMP
2.7.1 Clearing the Information About an IGMP Group
Context
CAUTION
The IGMP group that an interface dynamically joins is deleted after you run the reset igmp
group command. Receivers may not receive multicast information normally. Therefore, confirm
the action before run the command.
You can run the following commands to clear the information about an IGMP group in the user
view.
Procedure
l Run the reset igmp group { all | interface interface-type interface-number { all | group-
address [ mask { group-mask | group-mask-length } ] [ source-address [ mask { source-
mask | source-mask-length } ] ] } } command to clear the IGMP group that the interface
already dynamically joins.
l Run the undo igmp static-group { all | group-address [ source source-address ] }
command to clear the IGMP group that the interface already statically joins.
----End
2.7.2 Monitoring the Running Status of IGMP
Context
To check the running status of IGMP during routine maintenance, run the following display
commands in any view.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast 2 IGMP Configuration
Issue 01 (2009-07-28) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2-19
To Next Page
Loading...
Need help?
General
