Configurable Forwarding Control Parameters
You can determine whether to add the Generation ID to a Hello message, and configure the
interval for sending Join messages, period for keeping the forwarding status of a downstream
interface, and period for overriding the prune operation.
Configurable Frequency of Sending Join/Prune Messages
You can configure the interval for sending Join or Prune messages.
Configurable Assert Control Parameters
You can configure the period for keeping the Assert state on the interface of an S9300.
Changeable SPT Switchover Parameter Values
You can change the interval for checking the transmission rate of multicast packets and
conditions of the SPT switchover.
PIM-SSM
The SSM model provides a solution to specifying source multicast and maintains the relation
between the host and the S9300 through IGMPv3.
4.3 Logical Relationships Between Configuration Tasks
This section describes the logical relationships between the configuration tasks.
To make each configuration of PIM-SM take effect, you must configure the basic PIM-SM
functions. All other configuration tasks are optional and are not listed in sequence. You can
configure them as required.
4.4 Configuring Basic PIM-SM Functions
This section describes how to configure PIM-SM to implement ASM and SSM multicast models.
4.4.1 Establishing the Configuration Task
4.4.2 Enabling IP Multicast
4.4.3 Enabling PIM-SM
4.4.4 (Optional) Configuring a Static RP
4.4.5 (Optional) Configuring Dynamic RP Election
4.4.6 Checking the Configuration
4.4.1 Establishing the Configuration Task
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast 4 PIM-SM Configuration
Issue 01 (2009-07-28) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4-5
To Next Page
Loading...
Need help?
General
